|

|
- 2:1 INPUT RANGE
- EFFICIENCY
TO 88%
- SIX-SIDED SHIELD
- 2.6 x 3.0 x 0.4 INCHES
- ON/OFF
CONTROL
- OVER CURRENT PROTECTION
- SAFETY APPROVAL PENDING
|
| ELECTRICAL SPECIFICATIONS |
| All specifications are typical at nominal input, full load, and 25ΊC
unless otherwise noted |
| INPUT
SPECIFICATIONS |
Input
voltage range 12V nominal
........
..
..
...
9 to 18V
24V nominal
........
..
....
...
18 to 36V
48V nominal
........
..
....
...
36 to 75V Input filter
..................
.Pi
Type Over voltage shutdown.....................................................................20,38
or 78VDC Under voltage shutdown...............................................................8,17
or 34VDC, typ. Reflected ripple current..............................................................................75mA,
typ. |
| OUTPUT
SPECIFICATIONS |
Output
voltage accuracy Single, dual output.......................................................................................±2% max. Triple output, primary............................................................±2% max. (Adj. to Zero)
Auxiliaries...........................................................................................±5% max. Output voltage balance Dual output.................................................................................................±2% max. Triple output...............................................................................................±10% typ. Ripple and noise, 20MHz BW..
........1%
PK-PK of Vout. Line regulation, HL-LL Single output.............................................................................................±0.5% max. Dual output..................................................................................................±1% max. Triple output, primary...................................................................................±2% max.
Auxiliaries...........................................................................................±5% max. Load regulation, 100% to 10% Full Load Single
output.............................................................................................±0.5% max. Dual output..................................................................................................±1% max. Triple output, primary...................................................................................±2% max.
Auxiliaries...........................................................................................±5% max. Efficiency
..
........
.......SEE
TABLE Temperature coefficient
.
..........
.
..
±0.02%/ΊC Short circuit protection
.........
.......Continuous
Transient response recovery time, 25% load step change
.....
...........
500΅
sec Transient voltage peak deviation....................................................................2%
of Vo Minimum output current % lout rated (Main output) FDC40-xxD3305
(3.3V).....................................................................................20%
Dual and triple......................................................................................................20%
Over voltage protection threshold 3.3V Output........................................................................................................3.9V
5V Output...........................................................................................................6.2V
12V Output..........................................................................................................15V
15V Output..........................................................................................................18V |
| REMOTE ON/OFF CONTROL |
Control voltage referenced
to negative(-)input Compatibility
.
........
.
.CMOS, TTL
On-control
...............
...4.8V min. or Open Off-control
....
...
..0.4V
max. or Short |
| GENERAL
SPECIFICATIONS |
Switching
frequency
.......
..
185kHz, typ. Isolation voltage
.
.....
....
.1600VDC
min. Isolation
resistance
....
.....
..
.109Ohms, min. |
| ENVIRONMENTAL SPECIFICATIONS
(REFERENCE) |
Operating
temperature range
.
.......
...-25ΊC to +85ΊC Storage temperature
range
.......
.-55ΊC to +105ΊC Case temperature
........
.....
..................
+100ΊC,max.
Cooling
....
.......
...Free-air convection EMI
/ RFI
..
.......
...Six-Sided Continuous Shield |
| PHYSICAL SPECIFICATIONS |
Case Material
.............
Nickel-Coated
Copper wit Non-Conductive Base Dimensions
....
.
.....
.
......
...2.6
x 3.0 x 0.4 Inches
(66
x 76.2 x 10.2 mm) |
|